Monday, May 30, 2011

007 Toggle Clamp Modeling & Assembly - Part #6

In this tutorial, the toggle clamp will be assembled using all the parts that have been created throughout the previous sessions starting by tutorial No. #1 in which the procedure and the concept are described. You shall find all these tutorials in the blog Archive at the left bar of this page.



In The above images shown are the real images of the toggle clamp and the image of the reverse-modeled clamp. Here is the video that shows the simulation of the toggle clamp mechanism:

The assembly was done using the following steps:
  1. The handle support and the handle support mirror part are inserted and assembled using two coincidence constraints and one contact constraint.
  2. The handle and the handle mirror parts are inserted and assembled using two coincidence constraints and one contact constraint.
  3. The L-Plate and the L-Plate mirror part are inserted and assembled using two coincidence constraints with the handle support and the handle itself and one contact with the handle support.
  4. The L-Plate mirror is assembled also using two coincidence constraints with the handle support mirror and the handle mirror part and one contact with the handle support mirror part.
  5. The connection plate is inserted and assembled using two coincidence constraints with the handle support and the handle itself and one contact with the handle support.
  6. Another connection plate (SAME PART) is inserted and assembled using two coincidence constraints with the handle support mirror and the handle mirror part and one contact with the handle support mirror part.
  7. The four pins (SAME PART) are inserted and assembled one by one. They have two constraints for each, Coincidence constraint with the connection plate or the handle and contact constriant with the connection plate or with the L-Plate part.
Here is the video that shows the detailed assembly of the Toggle Clamp:



7 comments:

  1. Thank you Mohammed and wait for more tutorials soon!!

    ReplyDelete
  2. Great tutorials ! Is it possible to upload the CATIA parts ?
    Thanks !

    ReplyDelete
  3. Dear Toni,

    It is possible to upload the parts, but trust me it would be of more benefit if you create each part on your own and then assemble them. you will find the detailed dimensions of each part in the archive posts under "May". Enjoy Toni!!

    ReplyDelete
  4. Thats really good for my hw for catia thanks a lot!

    ReplyDelete
    Replies
    1. Dear Mehmet,

      Not at all, It is my pleasure !!

      For Your homework, you need to go through the seven catia modeling tutorials starting by

      www.catiatutorialz.blogspot.com/2011/05/002-toggle-clamp-modelling-assembly.html

      Awaiting your Homework results :)

      Best of Luck!

      Delete
    2. that is really good for my hw. Result is better than i hope :) i'm really thank to you and your blog .. it is very useful.:)

      Delete