In this tutorial, a Cube is modeled using parameters where all the edges of the cube are linked with only one parameter "L". Upon changing this parameter all the cube edges are changed accordingly. The only module used in this tutorial is "Part Design".
This tutorial is quite simple. The Parameter is defined and given the required length which is - in our case - 10mm. Then the sketch of the square is made up where the length of the two sides is linked through a formula to the "L" parameter. Using the Pad tool, the extrusion length is defined the same way. At the end of the tutorial, some manipulations were done on the cube to try different lengths of the edge.
Here is the video that shows the modeling of the Cube:
No comments:
Post a Comment